Can you still level and above ground pool even if there’s water in it? Sure you can! Here’s a guide on how to level an above ground pool with water in it.
Most people choose to level their above ground pools before the pool actually gets installed. However, there are times when the ground itself sinks after the pool was already set up.
That said, is there a way on how to level an above ground pool with water in it or is it already too late?
Fortunately, you can level an above ground pool even if there’s water inside. You just need to follow the steps we have below:
Contents
Why You Need To Level Above Ground Pool?
At this stage, you may have probably asked yourself if it is really necessary to level your above ground pool.
Can’t you just leave it on an unlevel ground? It doesn’t really affect you anyway, right?
Sure, it won’t affect you right now. But give it some time and you’ll see that the pressure will be shifted to one side. When it shifts to just one side, the whole structure of your above ground pool will collapse. This will leave your pool lopsided and maybe damaged in the long run.
It’s for that reason that you need to level your above ground pool. By right, you need to level your pool properly at the start. But if you weren’t able to, you can still learn how to relevel an above ground pool without fully draining the water inside.
How To Level An Above Ground Pool With Water In It (6 Steps)
Now that we’ve explained why you need to level your above ground pool, we’re going to give you the easiest way to level ground for pool without having to take out the water.
So, even if you already installed your above ground pool, you can still level it anytime you wish.
1. Determine Which Side Needs Leveling
In this type of situation, one side is probably lower than the other. To start, you need to first determine which side needs leveling and how much leveling needs to be done.
You can use a stake to mark the areas that need to be leveled. You can also use a measuring tape to get the exact measurements.
2. Drain Your Pool A Bit
We understand that draining the pool and putting the water back in takes a lot of time and effort that’s why we won’t ask you to drain the pool.
However, it is important to drain out A BIT of water to make the pool easier to handle. Just put your hose in the pool and drain it out to a bit over halfway.
3. Remove The Leveling Blocks
Dig up the foundation to show the leveling blocks underneath. The leveling blocks under the pool are what’s used to make the foundation of the pool. If one side is higher than the other, take out the leveling block that makes the pool higher.
4. Dig The Ground Lower
Once you’ve taken out the area that makes the pool lopsided, dig deeper into the ground. You can use a shovel to do that. When you have already created a deeper hole, you can put back the leveling blocks into the deeper hole. From there, you’ll be able to see if the pool is already leveled.
5. Repeat The Process
After you do that, all you need to do is repeat the process for all levels in the ground. Once you do this for all the unleveled sides, then you’re good to go. You can just refill the pool when you’re done.
Conclusion
As you can see, there are only 5 steps that you need to follow if you want to learn how to level an above ground pool with water in it. Of course, you need to be careful when doing this process because the pool might fall on you when you taking out the leveling blocks. So, make sure that you have an assistant with you when you’re leveling your pool.
Also, make sure that you have the right tools with you as well. You’ll need a shovel, hammer, and stake. If you feel like you need to buy some other tools, you can do some research and add them to your arsenal. But as far as this guide is concerned, the three tools above are the only ones you need.
Recommended Reading: