Even if your pool is already up, there are still ways on how to level above ground pool already up if you notice that it became lopsided.
Leveling your pool is pretty easy if you do it before pool installation.
But what if your pool is already set up with water inside and all the accessories on it?
Is there still a chance to level the pool so that the water doesn’t stick to one side?
Fortunately, there is a way to do so. As long as you follow the steps on how to level above ground pool already up that we provided below, you’ll have absolutely no problem. Leveling a pool that has been already set up may be harder than leveling a pool that hasn’t been installed, but it doesn’t mean it can’t be done.
That said, let’s get started with our guide:
Contents
Steps On How To Level Above Ground Pool That Is Already Up?
Check Where The Problem Started
Unless you didn’t level your pool properly at the onset, then the most likely cause of the lopsidedness is from some external factor. So, before you begin leveling your pool, it’s important to know the root cause of the whole problem in the first place. The problem could be a washout from under the pool, a rodent problem, or a classic case of the legs not being centered.
Drain The Pool Halfway
Once you find the root of the problem, we can start learning how to relevel an above ground pool. The first thing you’ll need to do is drain your pool. Fortunately, you don’t need to drain all of the water inside your pool. You just need to drain around 50% of your pool’s water so that your pool will become easier to handle as it will become lighter.
Take Out The Leveling Blocks
After you drained the pool, look for the side that’s lower and take out the leveling blocks. The leveling blocks are what will keep the pool leveled so if the pool is lopsided, you need to prop up the leveling blocks a bit.
Increase The Wall Level
The next step here is to use a shovel to pry up the wall at the very bottom of the leveling blocks. Just keep on prying it up until you reach the level you want.
Put The Blocks Back On
Once you reach the desired level, you can put the blocks back on. If you haven’t reached the level you want, take out the blocks again and pry even more. After that, put the blocks back on and check again.
Do This For All Sides
Now that you’ve done one side, all you have to do is repeat all the steps for all the sides.
Add More Soil To Cover The Blocks
When you’re done, you just need to put soil on the blocks to cover them up. Cover them with enough soil to make the ground compact. After that, add some water so the soil hardens.
Put Water Back In The Pool
Once you follow all the steps, you can just put back the water in the pool. When you’re done with that, observe the pool and see if it is still lopsided.
Frequently Asked Questions
Q: Is this the cheapest way to level ground for pool?
A: By far, this is one of the cheapest ways to level a pool that’s already been set up.
Q: What are some of the tools that I’ll need in order to do this?
A: The only thing you’ll really need is a shovel. You can use the shovel to pry the ground at the bottom of the leveling blocks and put the soil back on the leveling blocks.
Q: My pool is just slightly lopsided. Is it really necessary to level it?
A: You can ignore it for a while if you want but the problem will get worse over time. So, the best thing to do is to nip the problem in the bud and level the pool while it’s not so bad yet. When it gets really bad, your pool can get damaged.
Conclusion
If you’re worried about leveling your pool when it’s already set up, you can ease your mind a bit because it’s not that hard to do. In fact, learning how to level above ground pool already up just takes a total of 8 steps to do – and all of them are pretty simple.
If you have a pool that suddenly needs leveling, take out this guide and start following it. Enjoy!
Recommended Reading: