There is a way to fix pool levels without draining water. In this guide, we’ll teach how to fix an unlevel pool without draining to make things easier.
Is your pool unleveled or uneven?
Then all you need to do is level it up so the weight of the water won’t be shifted to just one side. The problem here is the draining.
Draining is actually a long and tedious process. Is there a way to do this process without draining? Fortunately, there is.
In this guide, we’ll teach you the steps on how to fix an unlevel pool without draining the water.
Here’s how to do that:
Contents
The Things You Need To Level Your Above Ground Pool
Before anything else you need to make sure that you’re prepared with all the necessary tools to get the job done. To start off, we’re going to list down some of the tools that this job requires.
Take a look at them below:
- Shovel
- Grovel
- Garden Hose
- Wheelbarrow
- Hammer
As you can see, these are pretty basic tools that you can usually find in a garden tool shed. If you don’t have some of them, you can buy them in a hardware store. But if you have everything with you on hand already, then we can begin with our guide on how to fix unlevel above ground pool.
How To Fix An Unlevel Pool Without Draining It
1. Drain Your Pool A Bit
Yes, we did say that you can level your pool without draining it– and you’re right! You don’t need to fully drain your pool. However, we highly recommend you to take some water out to make it easier to maneuver the pool.
You can actually level it while it’s full, but it’ll be much harder, so drain about almost half of the water first using your garden hose.
2. Take Out The Blocks
After you’ve emptied the pool a bit, the next thing to do is take out the leveling blocks under the pool. You should take out the leveling blocks on the uneven side so that the pool will even out.
You can use the shovel to pry the wall of the pool and use the hammer to knock the blocks. Just keep on taking out and putting blocks in place until the pool is leveled.
3. Add The Soil
When the pool is already leveled, you need to keep the balance in place by adding soil under the pool. You’ll need a wheelbarrow to carry the soil around and dump it into the area where you dug up the blocks. Make sure the spaces in the ground are all filled with soil so that your pool has a solid foundation.
4. Refill The Pool With Water
When the pool is leveled and completely steady, you can take out your garden hose again and fill the pool with water. You can now fill it up to the rim and swim in it.
As you can see, the entire process on how to fix an unlevel Intex pool was done in just 4 steps, so it’s pretty simple. Now, you may be tempted to just lower the high part of the swimming pool by taking out one block from the high side.
We do not recommend that you do this since it may cause complications in the future. Just take out one block from the high side then add it to the low side. That will help get the job done in a jiffy.
That’s the reason why we recommended you to take out some water in the first place. If you don’t, you’re going to have to lift a really heavy pool. With a half full pool, at least you won’t have that hard of a time maneuvering the pool. At the same time, you don’t need to drain so much water out.
Conclusion
Was learning how to fix an unlevel pool without draining tough?
It actually wasn’t because it’s a process that only takes a few steps. Now, we created this step by step guide because we believe it’s important to know each individual step by heart so that you can get the job done systematically. By having it done systematically, you’ll be much more efficient.
So, if you have an unlevel pool, don’t worry! Use this guide as your reference and you should have no problem.
Recommended Reading: