What happens if your pool overflows from a rainstorm? You must learn the fastest way on how to drain water from pool after rain to avoid damage.
It just rained. Now what? Do you drain water from your pool or not?
The ideal situation is, your yard will absorb the water. Then, you can remove some pool water and balance your water chemistry again.
However, in some cases, especially when there is a great overflow and you have an interior drainage system, your structure can be harmed and lead to contaminated water.
In the following, we’ll show you how to drain water from pool after rain fast.
Is Rain Water Bad For My Pool?
The short answer is yes. It can lead to inconsistent water chemistry, damaged surfaces, and unwanted contaminants.
Your water’s cleanliness relies on a particular proportion of chemicals. When your pool floods, it becomes compromised. Rainwater is acidic, so it triggers an imbalance.
Likewise, during rainstorms, your pool’s equipment can be messed up with the strong winds, eventually leading to damage.
Furthermore, rainwater carries toxins from debris that lead to water contamination.
At this point, the best course of action is to drain water from pool after rain fast before foul hazards like algae take over.
How To Drain Water From Inground Pool After Rain
1. Clean The Deck.
Clear any debris on the deck of the pool and do this with a garden hose. Ensure to spray away every dirt to prevent it from getting into the water.
2. Remove Debris Manually.
Attach a net to your pole to expel all leaves, twigs, and other dirt on the pool water. If the skimmer and pump are filled with debris, the filter won’t work well. You can use your hand to expel any dirt from the baskets too.
3. Turn On The Filter.
Get the water flowing to expel microscopic contaminants that the rain brought into your pool.
4. Brush Pool.
Utilize a decent pool brush to move dirt off from the pool ladders. You can also push the debris towards the bottom of your pool’s drain if you have one for an easier way.
Doing this is one of the best ways on how to drain water from above ground pool after rain, especially when there’s a great deal of debris. Keep in mind that before turning on your vacuum, make the filter adjusted to “waste” to remove any dirt and drain extra water. Continue vacuuming until all the junk is expelled. The waterline should arrive at the midpoint on the skimmer plate, which is approximately 6-8 inches from the pool.
6. Drain Water Partially.
If there’s a massive deal of water overflow, learning how to remove water from pool after rain in your pool may be intimidating. But if there’s not a lot of debris, you may merely switch the filter to “waste,” attach a backwash hose and turn on the pump. Again, midpoint on the skimmer plate is the ideal level.
7. Test And Maintain Water Chemistry.
Use a test kit to
see how the water’s balance has been affected. The pH level and total
alkalinity may have been dramatically stirred to low levels. Also, the rain may
reduce the sanitizing effect of chlorine, so it’s best to check its levels too.
Finally, check the stabilizer and calcium levels as they may have been impaired by the rain, which will eventually affect your pool’s performance.
Tips And Reminders
- Be proactive in knowing what to do with pool when it rains. When a major storm is coming, outmaneuver it by lowering the level of your pool water before it strikes. Cutting a few inches away will be a big help later on.
Also, remove outdoor furniture to save it from dropping into the pool when the wind gets strong.
- Disconnect all gas lines from your pool. Doing this will avoid gas leak when a storm hits hard and any form of inconveniences later on.
- Check if your drainage system is working optimally. The best way to save your pool from an overflow that eventually leads to damage is to keep your drainage checked. You can run a hose to test how fast the water runs.
- Ensure the deck is pitched marginally away the pool to make contaminants streaming out of your pool as opposed to into it.
To protect your pool from the acid that rainwater brings, you must ensure that your pool cover is properly installed. Here’s a useful blog about how to keep pool from sagging.
You have finally learned that while rainwater can be challenging in maintaining your pool, there’s always a way to solve things seamlessly.
Now you know how to drain water from pool after rain along with some concrete tips to prevent your water from overflowing.
As long as you follow the guidelines above, you won’t have to second guess if you’re doing the right thing and choosing the right product. Nothing can stop you now from enjoying the pool with your family!