You need to know how to clean the pool pump impeller to maintain good water circulation. Here’s a quick guide on how to do that in a few steps.
If you notice that your filter pressure is low or that your pump motor seems to be running weak, then there is probably a problem with your pump impeller.
But don’t worry because this problem isn’t such a big one. In fact, it doesn’t need any professional fixing at all. All it needs is actually just some good old maintenance. You just need to clean it up since a clog is the most probable issue when it comes to these kinds of problems.
The bigger question here is, how to clean pool pump impeller?
Luckily, cleaning swimming pool pump impeller is really easy. All it takes is a few steps to do. You don’t even need to have that much experience in pool maintenance to do it. You just need to follow our steps and you’re good to go.
How To Clean Pool Pump Impeller – Easy Steps For Declogging
Step 1: Determine The Pool Pump Impeller Clogged Symptoms
The first thing you need to do is determine the symptoms of a clogged pump impeller. You may have to be a little sensitive to spot these signs, but once you get used to doing this, it’ll be pretty easy.
First of all, you need to watch out for low whirring and grinding noises from the pump. Another symptom is that the pressure doesn’t go higher than half of what it usually does. Lastly, the basket cannot seem to be filled up to its normal capacity.
Step 2: Check The Hoses
Once you have determined clogging, the next step in how to clean clogged pool pump impeller is to check the hoses. There could be cracks in the hoses so take them out and bend them to see if they’re all working fine.
If they are, then go on to the next step. But if you see a damaged hose, then you may need to get it replaced.
Step 3: Take Out The Pump Basket And Lid
The next step is to get a coat hanger and some pliers. With these tools on hand, make sure you turn off the electricity and take out the basket lid and pump basket.
Step 4: Manipulate The Wire And Unclog The Impeller
Bring out the pliers and use it to bend the wire on one end. This is going to help you bring out the dirt. You can make a hook that’s around ½ inches in size. After that, put the wire into the opening of the impeller and use the wire to start cleaning out the debris and the dirt. The best way to do this is to go deep and pull it in and out. You’ll be able to pull out a lot of dirt in a short span of time.
Step 5: Put Everything Back In Place
After that, you can put the pump basket back and fill the pump with water. You may then replace the pump lid and try to use it again.
Step 6: Test The Pump Impeller
Now that you’re done learning how to clean swimming pool pump impeller, the last thing to do is simply turn back the electricity on your pump and test to see if everything works fine.
If the pump impeller still doesn’t seem to work properly, then maybe you may want to consider a full pool pump impeller removal and replacement. But only if the cleaning didn’t help with the situation. You may have to get a professional to take a look at it so that you can get it changed.
Conclusion
See how easy it is to clean the pool pump? You just learned how to clean pool pump impeller in just 6 steps. And all you needed was a pair of pliers and a coat hanger. Technically, the coat hanger is the tool that was used to clean your pool pump impeller.
So, now that you are ready with all of the knowledge that you need in order to clean your pool, then you can do it right away the moment you detect the signs.
It’s really as simple as that!
Recommended Reading: